EZ-LOK INSTALLATION GUIDE E-Z LOK external threads are standard size and pitch to permit use of standard drills and taps. No special tap sizes or installation tools are required. E-Z LOK inserts will not back out or vibrate loose. Immediately upon installation, microencapsulated Loctite® begins to set and the newly installed insert can be fastened to within minutes. In addition, the adhesive seals against liquids and gasses to pressures of 6,000 psi, and bonds to virtually all metals. For more information about E-Z LOK® products go to the E-Z LOK® website at: http://www.ezlok.com/

EZ-LOK Installation Steps

	Drill hole with standard drill to required pre-tap size.
	Tap hole with standard tap.
	Turn E-Z LOK home flush with bolt.
	Power drive tools are available for high volume installation.

Easy Removal

Use a standard screw and bolt extractor to back out a damaged insert and then replace it with a new insert. Removal is simply a matter of overcoming the resistance to torque-out which has been produced by the thread locking material.

Return to EZ-Lok

Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201 Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: sales@smithfast.com Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools