Installation Steps

	Drill hole the same diameter as anchor being used to any depth exceeding minimum enbedment. Clean hole. Please wear safey goggles.
	Drive anchor flush with surface of concrete.
	Expand anchor with setting tool. Anchor is properly expanded when shoulder of setting tool is flush with top of anchor.
	To set Anchor below surface: Drill hole deeper than anchor length. Thread bolt into anchor. Hammer anchor into hole until bolt head is at desired depth. Remove bolt and set anchor with setting tool.

Return to Multi-Set® Anchors

---

For more information about Red Head® products go to the Red Head® website at:
http://www.itw-ramset.com/

Smith Fastener Company, A California Corporation - 3613 East Florence Avenue, Bell, California, 90201 - Phone: ( 323 ) 587-0382 and ( 800 ) 764-8488 - FAX: ( 323 ) 587-8712 - E-mail: sales@smithfast.com - Copyright © 2000 by Smith Fastener Company - Please report website problems to: WebMaster - Last updated: June 22nd, 2000 - http://www.smithfast.com/multinst.htm