Red Head® Multi-Set II® Drop-In Anchors

Specified for anchorage into concrete

Drop-In, shell-type anchors feature an internally threaded, all steel shell with expansion cone insert and flush
embedment lip. Anchors are manufactured from plated carbon steel, 18-8 stainless steel and 316 stainless steel.
Anchors should be installed with carbide tipped hammer drill bits made in accordance to ANSI B212.15-1994
specifications. Anchors should be tested to ASTM E488 criteria and listed by ICBO and SBCCI. Anchors should
also be listed by the following agencies as required by the local building code: UL, FM, City of Los Angeles,
Metro Dade, California State Fire Marshal and Cal Trans. The anchors shown below are manufactured by
ITW/Ramset/Red Head. For more information about Red Head® products go to the Red Head® website at:
http://www.itwredhead.com/

	ANCHOR TYPE	KEY FEATURES
	Multi-Set II® RM Drop-In Anchors	Lip keeps anchor flush Easy Installation Keeps all rods same length Easy inspection Available in carbon steel, 18-8 Stainless and 316 Stainless Steel
	Multi-Set II® RL Drop-In Anchors	Below surface setting for easy patch work Higher performance potential with deep imbedment setting
	Multi-Set II® RX Drop-In Anchors	Optimized for use in hollow-core, pre-cast plank and post-tension slabs Lip keeps anchor flush Shallow drilling - Fast installation
	Multi-Set II® CL Coil Thread Anchors	Quick thread attachment Use coil rod on job Two diameters Easy inspection

Installation