Red Head® POLY-SET® Anchors Anchor Installation For more information about Red Head® products go to the Red Head® website at:http://www.itwredhead.com/

Solid Concrete Installation

	Drill hole at least 1/4 inch deeper than anchor length and insert anchor until flange is flush.
	Fasten fixture by inserting sheet metal screw through fixture and into anchor.
	Tighten screw.

---

Hollow material Installation

	Drill hole and insert anchor until flange is flush.
	Fasten fixture by inserting sheet metal screw through fixture and into anchor.
	Tighten screw and expand anchor after screw head is against fixture, tighten screw the number of additional turns indicated on the chart below.

---

Approximate Number of turns after screw head is against fixture

DRYWALL THICKNESS	PS-0608S	PS-1012S
3/8	7 - 9 Turns	9 - 11 Turns
1/2	5 - 7 Turns	8 - 9 Turns
5/8	3 - 4 Turns	6 - 7 Turns
3/4	1 - 2 Turns	4 - 5 Turns

Poly-Set® Anchors

Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201 Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: sales@smithfast.com Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools