 |
Red Head® Redi-Drive® AnchorsAnchor Installation StepsSpecified for anchorage into concrete, masonry, grout-filled block and hollow block. For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/ |
Redi-Drive® Installation
 |
Drill 3/16" diameter hole (1/4# for 3/8# pipe drive) to a minimum depth and clean hole. Please wear eye protection. |
 |
Insert anchor through material to be fastened and drive anchor with a 3-lb. hammer until the head is flush with surface or desired embedment. |
 |
The Redi-Drive® anchor is set. |
Redi-Tie-Drive Installation
 |
Drill 3/16" hole in concrete |
 |
Hammer in flat side of Redi-Drive® 1-1/4" |
 |
The Redi-Drive® is set. Tie acoustical or electrical drop wire to open hole in anchor. |
Redi-Pipe-Drive Installation
 |
Drill 3/16" hole in concrete for 1/4+ anchor. (1/4" diameter for 3/8" anchor) |
 |
Hammer in coupler end of anchor 1-1/4" for 1/4" anchor and 1-3/4" for 3/8" anchor. |
 |
The redi-Drive® is set. Run 1/4" or 3/8" threaded rod or bolt into anchor. |
Return to REDI-DRIVE®
Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201 Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: sales@smithfast.com Copyright © 2009 by Smith Fastener Company |
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools