Chicago Hardware Safety Anchor Shackle

Safety Anchor Shackles

DIMENSIONS IN INCHES								MAXIMUM LOAD TONS
INSIDE						EYE O.D.	PIN or BOLT DIA.
SIZE DIA.	WIDTH @ EYES	TOL. +/-	WIDTH @ BOW	LENGTH	TOL. +/-
1/2	13/16	1/16	1-1/2	1-15/16	1/8	1-1/4	5/8	2
5/8	1-1/16	1/16	1-7/8	2-1/2	1-8	1-11/16	3/4	3-1/4
3/4	1-1/4	1/16	2	3	1/4	1-7/8	7/8	4-3/4
7/8	1-7/16	1/16	2-5/8	3-1/4	1/4	2-1/8	1	6-1/2
1	1-11/16	1/16	2-3/4	3-3/4	1/4	2-1/2	1-1/8	8-1/2
1-1/8	1-13/16	1/16	2-15/16	4-1/4	1/4	2-5/8	1-1/4	9-1/2
1-1/4	2	1-16	3-1/4	4-1/2	1/4	3	1-3/8	12
1-1/2	2-3/8	1/8	3-3/4	5-3/4	1/4	3-1/2	1-5/8	17
Loads are based on a safety factor of 6 to 1. When tested all shackles are pulled at a uniform rate of speed in a direct tension. Any deviations such as angular lifts, shock loads, modification of the basic forging etc. will result in drastically reduced maximum loads.

Forged C-1035 steel.
Other sizes are available on request.
Available self colored or hot-dipped galvanized finish.
Other rust preventative coatings are available on a special basis.
Please specify the size, the finish, and the shackle type when ordering.

---

For more information about Chicago Hardware and Fixture products go to their website at: http://www.chicagohardware.com/

Smith Fastener Company, A California Corporation - 3613 East Florence Avenue, Bell, California, 90201 - Phone: ( 323 ) 587-0382 - FAX: ( 323 ) 587-8712 - E-mail: sales@smithfast.com - Copyright © 2000 by Smith Fastener Company - Last updated: May 22nd, 2006 - http://www.smithfast.com/shackle3.htm