Condrive 1000

Specified for anchorage into concrete, brick and block

The "original masonry" anchor the cuts its own threads into concrete, brick or block. Maximum performance is achieved because the Tapcon® anchor, the Condrive® Installation Tool, and the carbide-tipped Tapcon® Drill Bits are designed to work as a system. It is essential to use the Condrive® tool and the correct drill bit to assure consistent anchor performance. For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/


ADVANTAGES

  • Fast change from drilling to driving
  • Eliminates need for two tools
  • Eliminates need to change out chucks and bits
  • Special nut driver is recessed for torque control to reduce head breakage
  • Includes bits for all sizes hex and phillip head

TAPCON® Anchors




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools