Red Head® Dynabolt® Sleeve Anchors

Specified for anchorage into concrete, masonry, grout-filled block and hollow block

Sleeve type anchors feature a split expansion sleeve over a threadedstud bolt body and integral expander, nut and washer. Anchors are made of Plated Carbon Steel, or Type 18-8 Stainless Steel. Anchors should be installed with carbide tipped hammer drill bits made in accordance to ANSI B212.15-1994. Anchors should be tested to ASTM E488 criteria. For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/



ADVANTAGES
  • Anchor diameter equals hole diameter
  • Heavy Loading Capacity
  • Available in seven head styles
  • Preassembled for faster, easier installation
  • Available in 1/4" to 3/4" diameter up to 6-1/4" length
  • Dynabolt® can be installed through object being fastened
  • Zinc plated carbon steel and 304 stainless steel
  • Six-rib sleeve design improves holding power
  • Provides full 360° hole contact over large area and
    reduces concrete stress
  • No pre-spotting of holes necessary



A style for
every application

Installation




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools