Red Head® Dynabolt Gold®

Anchor Installation Steps

Specified for anchoring fixtures to concrete, concrete block or brick
For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/



Select a carbide drill bit with a diameter equal to the anchor diameter. Drill hole to any depth exceeding the desired embedment.
Clean hole or continue drilling to accomodate drill fines.
(concrete dust)
Please wear eye protection.
Drive the anchor into the hole through material being fastened until washer is flush with material being mounted.
Expand anchor by tightening the nut or head 2 to 3 turns.

Dynabolt Gold® Performance Tables | Return to Dynabolt Gold® page




Smith Fastener Company • 8181 State Street, South Gate, California 90280
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools