Drop Forged Eyebolt Image

DROP FORGED EYE BOLTS

Standard Shank Lengths - Plain Pattern




Plain
Pattern
Number
Bolt
Diameter
N.C.
Standard
Shank
Length
Blank
Part
Number;
Threaded
Self Colored
Part Number
Threaded
Zinc Plated
Part Number
Threaded
Galvanized
Part Number
1 1/4 1 11005 1 11605 3 26005 3 26105 0
2 5/16 1-1/8 11025 9 11625 1 26008 4 26108 1
3 3/8 1-1/4 11045 7 11645 9 26011 4 26111 1
4 7/16 1-3/8 110655 11665 7 26014 5 26114 2
5 1/2 1-1/2 11085 3 11685 5 26017 6 26117 3
6 9/16 1-5/8 11105 8 11705 0 26020 6 26120 3
7 5/8 1-3/4 11125 6 11725 8 26023 7 26123 4
8 3/4 2 11148 5 11748 7 26026 8 26126 5
9 7/8 2-1/4 11168 3 11768 5 26029 9 26129 6
10 1 2-1/2 11188 1 11788 3 26032 9 26132 6
11 1-1/8 2-3/4 11208 6 11808 8 26035 0 26135 7
12 1-1/4 3 11231 4 11831 6 26038 1 26138 8
14 1-1/2 3-1/2 11251 2 11851 4 26041 1 26141 8
The drop forged steel, C-1023, eyebolts shown here are supplied standard with a hot galvanized finish. They are threaded National Course before galvanizing and assembled with hex nuts tapped oversize to allow for galvanizing thickness. Special shank and thread sizes are also available.
Loads are based on a safety factor of 5 to 1. When tested all eye bolts are pulled at a uniform rate of speed in a direct tension. Any deviations such as angular lifts, shock loads, modifications of the basic forging etc. will result in drastically reduced maximum loads. For more information about Chicago Hardware and Fixture products go to their website at: http://www.chicagohardware.com/

Load Limits





Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools