Red Head® E-Z Ancor® Installation Steps

Specified for anchorage into Gypsum Wallboard

For more information about Red Head® products
go to the Red Head® website at:http://www.itwredhead.com/


Place #2 phillips screwdriver or cordless screwdriver
(#2 phillips bit) into recess of E-Z Anchor.
Press into Gypsum wallboard while turning
the anchor clockwise until seated flush.
Place fixture in position over installed E-Z Anchor®.
Insert screw (#8A or AB screws are recommended).
Tighten fixture into place.

Return to E-Z Anchors®




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools