Red Head® Multi-Set II®

Anchor Installation Steps

For more information about Red Head® products go to the Red Head® website at:
http://www.itwredhead.com/



Drill hole the same diameter as anchor being used to any depth exceeding minimum enbedment. Clean hole. Please wear safey goggles.
Drive anchor flush with surface of concrete.
Expand anchor with setting tool. Anchor is properly expanded when shoulder of setting tool is flush with top of anchor.
To set Anchor below surface:
Drill hole deeper than anchor length. Thread bolt into anchor. Hammer anchor into hole until bolt head is at desired depth. Remove bolt and set anchor with setting tool.

Return to Multi-Set® Anchors




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools