Red Head® Multi-Set II® Drop-In Anchors

Specified for anchorage into concrete

Drop-In, shell-type anchors feature an internally threaded, all steel shell with expansion cone insert and flush
embedment lip. Anchors are manufactured from plated carbon steel, 18-8 stainless steel and 316 stainless steel.
Anchors should be installed with carbide tipped hammer drill bits made in accordance to ANSI B212.15-1994
specifications. Anchors should be tested to ASTM E488 criteria and listed by ICBO and SBCCI. Anchors should
also be listed by the following agencies as required by the local building code: UL, FM, City of Los Angeles,
Metro Dade, California State Fire Marshal and Cal Trans. The anchors shown below are manufactured by
ITW/Ramset/Red Head. For more information about Red Head® products go to the Red Head® website at:
http://www.itwredhead.com/






ANCHOR TYPE KEY FEATURES
Multi-Set II®
RM Drop-In Anchors
  • Lip keeps anchor flush
  • Easy Installation
  • Keeps all rods same length
  • Easy inspection
  • Available in carbon steel,
    18-8 Stainless and 316 Stainless Steel
Multi-Set II®
RL Drop-In Anchors
  • Below surface setting for easy patch work
  • Higher performance potential with deep imbedment setting
Link to Multi-Set® RX Drop-In Anchors Multi-Set II®
RX Drop-In Anchors
  • Optimized for use in hollow-core, pre-cast plank and post-tension slabs
  • Lip keeps anchor flush
  • Shallow drilling - Fast installation
Multi-Set II®
CL Coil Thread Anchors
  • Quick thread attachment
  • Use coil rod on job
  • Two diameters
  • Easy inspection

Installation




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools