Red Head® POLY-SET® Anchors

Anchor Installation

For more information about Red Head® products go to
the Red Head® website at:http://www.itwredhead.com/



Solid Concrete Installation

Drill hole at least 1/4 inch deeper than anchor length
and insert anchor until flange is flush.
Fasten fixture by inserting sheet metal screw
through fixture and into anchor.
Tighten screw.



Hollow material Installation

Drill hole and insert anchor until flange is flush.
Fasten fixture by inserting sheet metal screw
through fixture and into anchor.
Tighten screw and expand anchor after screw head is
against fixture, tighten screw the number of additional
turns indicated on the chart below.



Approximate Number of turns after screw head is against fixture

DRYWALL
THICKNESS
PS-0608S PS-1012S
3/8 7 - 9 Turns 9 - 11 Turns
1/2 5 - 7 Turns 8 - 9 Turns
5/8 3 - 4 Turns 6 - 7 Turns
3/4 1 - 2 Turns 4 - 5 Turns

Poly-Set® Anchors




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools