Recoil's Helical Wire
Thread Insert Installation Guide




Drill to clear out the damaged thread
Use the STI tap to re-thread.
Tap thread should match up with the bolt.
Wind insert with light downward pressure 1/4 to
1/2 turn below the surface, driving tang towards
the bottom of the hole.
Remove tool, turn 90° and tap down sharply. For fine thread inserts long nose pliers may be used.


Return to Recoil Inserts




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools