Red Head® REDI-BOLT®

Anchor Installation Steps

Specified for anchorage into solid concrete and concrete fill



Select a carbide drill bit with a diameter equal to the anchor diameter. Drill hole to any depth exceeding the desired embedment.
Clean hole or continue drilling to accomodate drill fines. (concrete dust)
Please wear eye protection.
Drive the anchor into the hole through material being fastened until washer is flush with material.
Expand Redi-Bolt® by tightening the anchor 3 to 5 turns, or to the specified torque requirements.

Redi-Bolt® Performance Tables

Return toRedi-Bolts®


For more information about Red Head® products go to the Red Head® website at:
http://www.itwredhead.com/

Smith Fastener Company, A California Corporation - 3613 East Florence Avenue, Bell, California, 90201 - Phone: ( 323 ) 587-0382 and ( 800 ) 764-8488 - FAX: ( 323 ) 587-8712 - E-mail: [email protected] - Copyright © 2000 by Smith Fastener Company - Please report website problems to: WebMaster - Last updated: June 22nd, 2000 - http://www.smithfast.com/rediinst.htm