Round Pin Anchor Shackle

Round Pin Anchor Shackle

Forged C-1035 steel. Available self colored or hot-dipped galvanized finish.
Other rust preventative coatings are available on a special basis.
Please specify the size, the finish, and the shackle type when ordering. For more information about Chicago Hardware and Fixture products go to their website at: http://www.chicagohardware.com/



DIMENSIONS IN INCHES
INSIDE EYE
O.D.
PIN or
BOLT
DIA.
MAXIMUM
LOAD TONS
SIZE
DIA.
WIDTH
@ EYES
TOL.
+/-
WIDTH
@ BOW
LENGTH TOL.
+/-
3/16 3/8 1/16 9/16 7/8 1/16 5/8 1/4 1/3
1/4 15/32 1/16 3/4 1-1/8 1/16 3/4 5/16 1/2
5/16 17/32 1/16 15/16 1-1/4 1/16 7/8 3/8 3/4
3/8 21/32 1/16 1-1/8 1-7/16 1/8 1 7/16 1
7/16 23/32 1/16 1-5/16 1-11/16 1/8 1-1/8 1/2 1-1/2
1/2 13/16 1/16 1-1/2 1-15/16 1/8 1-1/4 5/8 2
5/8 1-1/16 1/16 1-7/8 2-1/2 1-8 1-11/16 3/4 3-1/4
3/4 1-1/4 1/16 2 3 1/4 1-7/8 7/8 4-3/4
7/8 1-7/16 1/16 2-5/8 3-1/4 1/4 2-1/8 1 6-1/2
1 1-11/16 1/16 2-3/4 3-3/4 1/4 2-1/2 1-1/8 8-1/2
1-1/8 1-13/16 1/16 2-15/16 4-1/4 1/4 2-5/8 1-1/4 9-1/2
1-1/4 2 1-16 3-1/4 4-1/2 1/4 3 1-3/8 12
1-3/8 2-1/4 1/8 3-1/2 5-1/4 1/4 3-1/4 1-1/2 14
1-1/2 2-3/8 1/8 3-3/4 5-3/4 1/4 3-1/2 1-5/8 17
Loads are based on a safety factor of 6 to 1. When tested all shackles are pulled at a uniform rate of speed in a direct tension. Any deviations such as angular lifts, shock loads, modification of the basic forging etc. will result in drastically reduced maximum loads.




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools