Safety Chain Shackle

Safety Chain Shackle

Forged C-1035 steel. Additional sizes can be supplied on request. Available self colored or hot-dipped galvanized finish. Other rust preventative coatings are available on a special basis. Safety shackles are of the same specifications as the regular types except for the bolt, nut and cotter pin.
Please specify the size, the finish, and the shackle type when ordering. For more information about Chicago Hardware and Fixture products go to their website at: http://www.chicagohardware.com/


DIMENSIONS IN INCHES
SIZE
DIA.
INSIDE EYE
O.D.
PIN or
BOLT
DIA.
MAXIMUM
LOAD TONS
WIDTH
@ EYES
TOL.
+/-
LENGTH TOL.
+/-
1/2 13/16 1/16 1-11/16 1/8 1-1/4 5/8 2
5/8 1-1/16 1/16 2 1/8 1-5/8 3/4 3-1/4
3/4 1-1/4 1/16 2-5/16 1/4 1-7/8 7/8 4-3/4
7/8 1-7/16 1/16 2-7/8 1/4 2-1/8 1 6-1/2
1 1-11/16 1/16 3-1/4 1/4 2-1/2 1-1/8 8-1/2
Loads are based on a safety factor of 6 to 1. When tested all shackles are pulled at a uniform rate of speed in a direct tension. Any deviations such as angular lifts, shock loads, modification of the basic forging etc. will result in drastically reduced maximum loads.




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools
>