SHACKLES

There are six different models of shackles to chose from. Size, work load and trademark
are permanently marked on all shackles. Loads are based on a safety factor of 6 to 1. When
tested, all shackles are pulled at a uniform rate of speed in a direct tension. All types of shackles
are available in a self-colored or hot-dipped galvanized finish. When ordering please specify the
size, finish and type of shackle. Other rust preventative coatings are available on a special basis.

Shackles meet Federal Specifications RRC-271d Type IV. Any deviation such as angular lifts, shock loads,
modification of the basic forging, etc. will result in drastically reduced maximum loads.

Link to Safety Anchor Shackles  

Round Pin Anchor Shackle Class I

Link to Screw Pin Anchor Shackles  

Screw Pin Anchor Shackle Class II

Link to Safety Anchor Shackles  

Safety Anchor Shackle Class III

Link to Class 1 Round Pin Chain Shackles  

Round Pin Chain Shackle Class I

Link to Class 2 Screw Pin Chain Shackles  

Screw Pin Chain Shackle Class II

Link to Class 3 Round Pin Chain Shackles  

Safety Chain Shackle Class III





Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools