Red Head® STUD Anchors

Specified for anchorage into concrete

Commonly used to anchor equipment to concrete slabs. Stud Anchors are available in either Carbon or Stainless Steels. Available sizes: From 1/4-20 to 3/4-10 thread and from 1-3/4 to 6-1/4 lengths. Stud Anchors feature a bolt body and pre-assembled expander plug. Anchors should be installed with carbide tipped hammer drill bits made in accordance to ANSI B212.15-1994. Anchors are tested to ASTM E488 criteria and listed bt SBCC. Anchors are listed by the following agencies as required: UL,FM, City of Los Angeles. Meets or exceeds U.S. Government G.S.A. specification FF-S-325 Group VIII, Type 2. For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/



ADVANTAGES

  • Fast and Easy to install
  • Anchor diameter equals hole diameter
  • Pre-assembled - Easy to set
  • Install anchor directly through fixture
  • Bottom-bearing design is ideal for jacking
    and leveling operations
  • Hammer-driven expansion design eliminates torque requirements,
    for dependable holding capacity

Installation




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools