Red Head® TAPCON Anchors

Specified for anchorage into concrete, brick and block

The "original masonry" anchor the cuts its own threads into concrete, brick or block. Maximum performance is achieved because the Tapcon® anchor, the Condrive® Installation Tool, and the carbide-tipped Tapcon® Drill Bits are designed to work as a system. It is essential to use the Condrive® tool and the correct drill bit to assure consistent anchor performance. For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/



ADVANTAGES

  • Works in all masonry base materials
  • Removable and reusable
  • Fast and easy
    • Three anchors a minute
  • Slotted Hex and Phillips Flat Head styles
  • No hole spotting or inserts required
  • Excellent corrosion protection
    • Climaseal® coated
  • Hi-Lo Threads with notches cut into masonry materials for greater stability and pullout values
  • Lengths from 1-1/4 to 4 inches for the 3/16 diameter and up to 6 inches for the 1/4 inch diameters


Self Threading Anchors
Now available are the Large Diameter Tapcon (LDT)

Features Sizes
  • Anti-rotation serrated washer
  • Extra large hex washer head
  • Length ID head stamped
  • Through-fisture fastening
3/8" - 3/4"
1.3/4 - 6-1/4"

Installation




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools