Red Head® TAPCON Anchor Installation

Specified for anchorage into concrete, brick and block.
For more information about Red Head® products go to the Red Head® website at:http://www.itwredhead.com/



With sleeve off and drill bit exposed, drill pilot hole 1/4" deeper than recommended anchor embedment. Snap proper anchor socket into end of sleeve. Slide drive sleeve over drill bit.
Insert head of Tapcon® anchor into hex or phillips socket.
Put point of anchor into pre-drilled hole and drive until anchor is fully seated.

Speed up the installation process with
a CONDRIVE 1000 Tool Kit

TAPCON® Anchors




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools