Red Head® TRUBOLT®

Wedge Anchors Installation Steps

Specified for anchorage into concrete
For more information about Red Head® products go to the Red Head® website at: http://www.itwredhead.com/



Using a bit whose diameter equals the anchor diameter, drill hole to any depth exceeding the minimum embedment. Clean hole.
Assemble anchor with nut and washer so that the top of the nut is flush with the top of the anchor. Drive anchor through material to be fastened so the the nut and washer are flush with surface of material.
Expand anchor by tightening nut 3 to 5 turns or to the specific torque requirement.

TRUBOLT® | Performance Tables




Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201
Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: [email protected]
Copyright © 2009 by Smith Fastener Company

Hitch Pins | Construction/Lifting | Blind Rivets | Dowel Pins | Cotter Pins | Nuts, Bolts, Screws, Washers
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools