 |
Red Head® TAPCON Anchor InstallationSpecified for anchorage into concrete, brick and block.For more information about Red Head® products go to the Red Head® website at:http://www.itwredhead.com/ |
 |
With sleeve off and drill bit exposed, drill pilot hole 1/4" deeper than recommended anchor embedment. Snap proper anchor socket into end of sleeve. Slide drive sleeve over drill bit. |
 |
Insert head of Tapcon® anchor into hex or phillips socket. |
 |
Put point of anchor into pre-drilled hole and drive until anchor is fully seated. Speed up the installation process with a CONDRIVE 1000 Tool Kit |
TAPCON® Anchors
Smith Fastener Company • 3613 East Florence Avenue, Bell, California, 90201 Phone: ( 323 ) 587-0382 • FAX: ( 323 ) 587-8712 • E-mail: sales@smithfast.com Copyright © 2009 by Smith Fastener Company |
Threaded Inserts | Anchors | Pins | Automotive | Weatherhead Pipe Fittings | Cutting Tools